This article explains how to program both driving and seating in Ability Drive®. For the mode button to be turned on to access seating the Enhanced Display needs to be mounted next to the eye gaze device. Please contact us and we will remote into the eye gaze device and turn the mode button on. Phone (425)242-3902 or support@tolttechnologies.com
Note: Ability Drive® is not safe to use with QLogic 2.0 based wheelchairs from 2017 and earlier.
Video of Setup on an Enhanced Display (High Quality)
Video of Setup on an Enhanced Display (Fast Download)
*A PDF of this guide can be found at the bottom of this article*
Quantum Programming Guide for Quantum QLogic 3.0
First, plug in the hand held programmer.
Step 1: Select Program Adjustments from the Main Menu
Step 2: Select Startup Configuration from the Program Adjustments Menu
Set Input Device = Input device selection screen
Set Input Device Selection = Power on Device
Step 3: Select Enhanced Display from the Program Adjustments Menu
Select Profile Setup
Set Profile 1 = Drive 1 (Slow Indoor Driving)
Set Profile 2 = Disabled (Optional Step: Drive 2 - Outdoor Moderate Driving)
Set Profile 3 = Disabled
Set Profile 4 = Disabled
Set Profile 5 = Disabled
Set Profile 6 = Seat
Select Input Configuration
Set ED Input Configuration = 4 Switch
Select Device Options / Timing
Set Device Double Command = Disabled
Select D-Sub (9-pin)
Set D-Sub Supervision = Disabled
Set Mode Long Command = Inactive
Set Mode Double Command = Inactive
Set D-Sub Mode E-Stop = Off
Select Switch Option / Timing
Set On / Off Jack Switch Type = 1 Switch
(this is the buddy button to turn off the chair)
Select Jack Command
Select Jack 1
Set On / Off Jack Short Command = Power Off
Select Menu Settings
Set Menu Navigation Mode = Manual
Select Standby Select
Set Standby Select = Disabled
Select Sleep
Set Sleep Power Mode = Disabled
Select Latch Driving
Set Latch Driving Visibility = Disabled
Select User Speed Adjust
Set User Speed Adjust = Disabled
Select Profile Change Stop
Set Profile Stop Drive = Enabled
(this setting is important to ensure that the chair comes to a stop before accessing seating)
Step 4: Select Seat from the Program Adjustments Menu
Select Seat Settings
Set Seat Navigation = Standard
Set Seat Head Left / Right Swap = No
Set Seat Enabled While Driving = No
Make sure the chair is set to use Profile 1.Make sure the chair speeds, seating and modes are set appropriately and tested for the client's environment.